Development and Validation Method for Silica Determination by Spectrophotometry in Some Herbs and Pharmaceutical Formulations

ABSTRACT

A spectrophotometric method for determination of silica in herbs and herbal pharmaceutical products has been developed and validated. The method showed excellent accuracy and precision with S.D. 1.67 and RSD 1.72%, 2.75%, respectively. The established linearity range was 0.05–0.5 μg/mL(r² > 0.99974). The recovery of silica from spiked placebo was > 95% over the linear range. The method has been successfully used in the analysis of silica in raw material and herbal pharmaceutical formulations. This validated method proved to be rapid and less costly.     

An HPLC method for simultaneous quantitative determination of seven secoiridoid glucosides separated from the roots of Ilex pubescens

A simple and specific high‐performance liquid chromatographic method has been developed and validated to simultaneously determine seven secoiridoid glucosides for the first time. Three of them were separated from the ethanolic extract of the roots of Ilex pubescens for the first time, namely nuezhenide A, ligusides B and oleonuezhenide. In quantitative analysis, all of the calibration curves showed good linear regression (r > 0.999) within the tested ranges, and the mean recoveries of three different concentrations ranged from 97.6 to 101.2%. The limit of detection and limit of quantification were <4.18 and 11.63 ng mL⁻¹, respectively. The relative standard deviation for repeatability and the precision of seven analytes were <3.4 and 1.9%, respectively. The established method was successfully applied to simultaneous determination of seven secoiridoid glucosides in 11 batches of samples collected from different habitats in China.     

Development and validation of a high‐performance liquid chromatography method for determination of lisinopril in human plasma by magnetic solid‐phase extraction and pre‐column derivatization

A sensitive, reliable and simple HPLC method was developed for the determination of lisinopril in human plasma. The method consists of extraction and clean‐up steps based on magnetic solid‐phase extraction and pre‐column derivatization with a fluorescent reagent. The mobile phase consisted of a mixture of methanol–sodium dihydrogen phosphate (pH 3.0; 0.005 m ; 75:25, v/v). The flow rate was set at 0.7 mL/min. Fluorescence detection was performed at 470nm excitation and 530nm emission wavelengths. Total chromatography run time was 5 min. The average extraction recovery of lisinopril and fluvoxamine (internal standard) was ≥82.8%. The limits of detection and quantification were determined as 1 and 3 ng/mL respectively. The method exhibited a linear calibration line over the concentration range of 3–1000 ng/mL with coefficient of determination (r²) of ≥0.98. The within‐run and between‐run precisions were satisfactory with values of CV of 1.8–12.8% (accuracy from 99.2 to 94.7%) and 2.4–13.7% (accuracy from 99.5 to 92.2%), respectively. These developments led to considerable improvement in method sensitivity and reliability. The method was validated according to the US Food and Drug Administration guidelines. Therefore, it can be considered as a suitable method for determination of lisinopril in plasma samples.     

Residual level of dimethachlon in rice‐paddy field system and cooked rice determined by gas chromatography with electron capture detector

In this study, a modified quick, easy, cheap, effective, rugged and safe method coupled with gas chromatography with electron capture detection was established to determine dimethachlon residues in paddy soil, rice husk, rice straw, brown rice and cooked rice. The limits of quantification of dimethachlon were 0.01 mg/kg for paddy soil, brown rice and cooked rice and 0.02 mg/kg for rice straw and rice husk. The mean recoveries were in the range 78.59–104.7% with relative standard deviation values of <10% for dimethachlon in the five matrices. For field experiments, the final residues of dimethachlon in paddy soil were < 0.05 mg/kg and were < 1.21 mg/kg in rice straw from six sites. The final residues of dimethachlon in the brown rice at 21, 28 and 35 days after spraying from six sites were 0.08–7.58 mg/kg, and 0.16–30.1 mg/kg in rice husk. Our six test sites covered the main rice–producing areas of China. The routine rice cooking process of a Chinese family could apparently increase the removal of dimethachlon in rice compared with brown rice, and the reduction ratios were > 96%.     

Spectroscopic and X‐ray structural characterization of new polymeric organotin(IV) carboxylates and their in vitro antifungal activities: Part II

The reactions of R₃SnCl (R = Me, Bu or Ph) with sodium 4‐phenylbutyrate, Na(OPh^b), in EtOH yielded three polymeric triorganotin carboxylates, namely [R₃Sn(OPh^b)]_n (R = Me ( 1 ), Bu ( 2 ) or Ph ( 3 )). All complexes were spectroscopically characterized using Fourier transform infrared, ¹¹⁹Sn Mössbauer, ¹H NMR, ¹³C{¹H} NMR and ¹¹⁹Sn{¹H} NMR spectral techniques. In addition, the crystal structures of 1 and 3 were determined using single‐crystal X‐ray diffraction. Their polymeric structures are sustained by bridging carboxylates which connect two five‐coordinate Sn(IV) centres. Each metallic cation displays a distorted trigonal bipyramidal coordination geometry (Addison's parameters ranging from 0.84 in 1 to 0.77–0.91 in 3 ), with the oxygen atoms occupying the apical positions and the organic groups at the equatorial corners. The one‐dimensional zigzag chains of 1 propagate along the b ‐axis, whereas 3 displays wave‐like double polymeric chains along the b ‐axis. For both 1 and 3 , parallel one‐dimensional polymeric chains are interconnected by C─H⋅⋅⋅π interactions. The antifungal activity of 1 – 3 was screened against Candida albicans (ATCC 18804), C. tropicalis (ATCC 750), C. glabrata (ATCC 90030), C. parapsilosis (ATCC 22019), C. lusitaniae (CBS 6936) and C. dubliniensis (clinical isolate 28). The antifungal activity of 3 was noteworthy since it was not only more active than 1 and 2 , but also more active than the control drugs (nystatin and fluconazole nitrate) in some cases.     

Determination of As(III) using developed dispersive liquid–liquid microextraction and flame atomic absorption spectrometry

The method relies on selective complexation of As(III) with a suitable chelating agent followed by dispersive liquid–liquid microextraction (DLLME) method. Flame atomic absorption spectrometry (FAAS) equipped with microsample introduction system was utilised for determination of As(III). 1-Undecanol and acetone were used as extraction solvent and disperser solvent respectively. Some effective parameters on complex formation and extraction have been optimised. Under the optimum conditions, the enrichment factor of 108 for As(III) was obtained from 9.8?mL of water samples. The calibration graph was linear in the range of 2–15?µg?L^?1 with detection limits of 0.60?µg?L^?1 for As(III). The relative standard deviation (R.S.D.) for ten replicate measurements of 5.00?µ?gL^?1 of As(III) was 6.2%. Operation simplicity and high enrichment factors are the main advantages of DLLME for the determination of As(III) without necessity for hydride generation in water samples.     

Use of 2, 3-Butanedione Monoxime for Homogeneous Precipitation of Nickel (II)

Abstract

The solid monoxime of 2, 3-butanedione is a more convenient material than liquid dione for the homogenous generation of DMG. 2, 3-butanedione dioxime. Determinations of Ni in steels and in pure Ni(II) solutions have shown the optimum pH and order of adding reagents. Gravimetric and/or an EDTA titrimetric finish are possible for a method of reliability within ± 0.2 mg of Ni in 50–150 mg Ni. The solid has the same character and filterability as that from the 1960 dione method of Salesin and Gordon¹.     

Spectrophotometry Determination Of Boron With 4-(P-Sulfophenylazo)-1, 8-Dihydroxynaphthalene

Abstract

4-(p-Sulfophenylazo)-l, 8-dihydroxynaphthalene (SPADN) was synthesized to study as a new reagent for the spectro-photometric determination of boron, measuring its absorbance on addition of boron present as boric acid at pH 8.6. The procedure involved mixing aliquots of the sample, ammonium buffer, EDTA and SPADN solutions. Various exchange equilibrium constants in the ion-association extraction systems of SPADN with zephiramine were also determined.     

The statistical significance of selected sense–antisense peptide interactions

Sense and antisense peptides, encoded by sense and corresponding antisense DNA strands, are capable of specific interactions that could be a driving force to mediate protein–protein or protein–peptide binding associations. The complementary residue hypothesis suggests that these interactions are founded upon the sum of pairwise interactions between amino acids encoded by corresponding sense and antisense codons. Despite many successful experimental results obtained with the hypothesis, however, the physicochemical basis for these interactions is poorly understood. We examined the potential of the hypothesis for general identification of protein–protein interaction sites, and the possible role of the hypothesis in determining folding in a broad set of protein structures. In addition, we performed a structural study to investigate the binding of a complementary peptide to IL‐1F2. Our results suggest that complementary residue pairs are no more frequent or conserved than average in protein–protein interfaces, and are statistically under‐represented amongst contacting residue pairs in folded protein structures. Although our structural results matched experimental observations of binding between the peptide and IL‐1F2, complementary residue interactions do not appear to be dominant in the bound structure. Overall, our data do not allow us to conclude that the complementary residue hypothesis accounts for specific sense–antisense peptide interactions. © 2012 Wiley Periodicals, Inc.     

Electron Capture Determination of Propoxyphene from Human Plasma

Abstract

A procedure for the determination of propoxyphene (α-d-dimethylamino-1, 2 -diphenyl-3 -methyl-2 -propionoxybutane) in plasma is reported. The method is based on the electron capture characteristics of propoxyphene. The plasma is rendered basic to generate the free amine and extracted with ether. The extract is analyzed by gas chromatography using a 4 foot OV-225 column. An internal standard of imipramine hydrochloride is used to quantitate the propoxyphene. This internal standard is carried through the entire procedure. The ratio of the peak heights of propoxyphene to imipramine is compared to ratios obtained from standards placed in plasma and treated in the same manner as the samples. Six subjects were given propoxyphene at different time intervals, and the data are presented concerning these subjects.